Search results

Iv got method to it now. I rub it on my lips just to taste it and if its not foul and my lips don't swell up within a few hours it gets a small taste. If its passes those tests it get a bigger taste the next time i come across it so long as i dont end up on the toilet the entire day😅🤣

I have no idea. The I side of them tasted sweet with a deep red colour. I have a habit of having a little taste of new plants to see if they are edible or not. These seemed to be.

Went for a ride and saw this out near the salt lakes and thought of this conversation. I picked a few of the seed pods off the floor to bring home and plant too, I'm regretting that decision now though as it turns out they are full of fine hair like stings and my hand is covered in them haha!

Just come back from a ride around the salt lakes off road ( bush bashin ) and there I can see an improvement in the bottom range, a huge improvement mid range and somewhat in-between in the high range. The rear wheel is now much more playfully off road and its breaking traction a lot more when...

Wish I had done the same. I have a 22 model but I hate the damn tripper. The screen is too bright. The clock on it runs ridiculously fast ( within a month or two not connected to Bluetooth and its 15 minutes fast ) and I used it once and didn't like it.

So test ride today after the ten minute break in process and there is a slight noticeable difference at higher RPMs I wouldn't call it a 20% increase but I don't have the open cover yet and it's just by the seat of my pants feeling. But there is certainly something there. Will save and do the...

Finaly managed to get the cam into the bike and boy was the engine cover stuck on tight with the silicone gasket sealant from the factory. Most of the time doing the job was just getting that off. Will give the new silicone a day to set and test it tomorrow. Had to redo the valve adjustments too...

Yes found it thankyou

Thankyou. I managed to get the cam cover plate off just the cylinder head now. They stick it on well and tight that is for sure. Do you k ow where you can get another cam cover plater from?

Anyone got any advice on how to get the cylinder head off. I've followed the instructions but the thing just won't budge. Even having issues removing the small cam shaft cover. I turned it clockwise the went to pull it out like I says in the instructions and it snapped. Any help would be...

New cam arrived within 7 days from the UK to AU which is amazing since it takes longer than that for orders to arrive from within Australia. Will fit it this weekend.

I've seen videos of tiny women lifting much bigger bigger BMWs and yet I always hate lifting my little himalayan. There definitely a technique to getting it up.

The little grays are not so bad but the the male reds can get huge. Have muscles like they are body builders too. They are generally pretty docile, especialy the femails but there seems to be one dominant male out of the larger mobs. They grow very big and can be very aggressive.

The problem with the roos is after a few weeks/months with very little or no rain the only greenery is at the side of the road from where the water runs off. This then becomes the only feed for them and they hang around the roads. Then the Eagles tend to feed on all the road kill which then...

That is some very terrible work from both sides of the emergency services. And one hell of a story, not sure anyone will be able to beat that!

The biggest problem is suicidal roos and emu's. I've made a funny noises after having a roo decide to change its mind crossing a road or track half way through.

Fingers crossed. The braced handle bar is my next buy. Iv bent my bars 5 times now and they keep getting easier to bent back which worries me that they might snap soon.

Most are invasive species but we don't have many here. There are plenty of thorny bushes though.

I rode my mates thumper through a farmers fence when I was 10. He never let me touch his bike again after that 🤣

I'm too looking at getting a new braced handlebar. Hitchcocks sell one that fits. But I think you need to get new bolts for the bar end weights but they sell them too.